Elo Touch Solution 1919L Guide de l'utilisateur télécharger pdf (Page 9)

Interface Connection

Note: Before connecting the cables to your touchmonitor and PC, be sure that the computer and touchmonitor

are turned off.

1. Connect DC cable of the power brick to the monitor and the other end through AC power cable

to the AC outlet.

2. Connect one end of either the touchscreen serial (RS232) cable or the touch screen USB cable

(but not both) to the rear side of the computer and the other end to the LCD monitor. Tighten by

turning the two thumb screws clockwise to ensure proper grounding.

3. Connect one end of the video cable to the rear side of computer and the other to the LCD monitor.

Tighten by turning the two thumb screws clockwise to ensure proper grounding.

4. Connect one end of the audio cable to the rear side of computer and the other to the LCD

monitor.

5. Facing the monitor, press the power button located on the underside of the botom-right corner

of the monitor.

Speakers and Audio

The touchmonitor includes two built-in speakers. To use the speakers, plug in the audio cable to

the Audio Input port and connect the other end to your computer.

To use headphones, plug in the headphones to the Audio Output port shown a bove. When

headphones are connected, the sound plays through the headphones only.

The volume and muting of the sound can be adjusted by using the “Audio” choice from the On-

Screen Display (OSD) Control panel menu as described on page 3-19.

321

Power Brick

USB Cable

Serial Cable

VGA Cable

Audio Cable

Headphone Cable

2-9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 36 37

Pas de commentaire

Elo Touch Solution 1919L Guide de l'utilisateur Page 9